"must be in back" requirement when Home Depot installs a dryer and was wondering if this is a code requirement or Home Depot's requirement. Use a 90-degree elbow at the stove to avoid kinking the gas tubing when you push the stove against the wall. Spray the connection on the gas line that extends from the wall where the flexible gas hose connects to it with the detergent and water mixture. Replace them with approved ball valves. Coat all threaded pipe connections with pipe thread compound before assembly. Once you get your new gas dryer home, you must safely connect it to the gas line. The place where you purchased the dryer usually has people who also can install it for you. Connections for flexible soft copper are made by flaring the end of the soft copper tubing with a special flaring tool and installing flare fittings that have a matching cone-shaped meeting surface.
Gas Dryer, connector Kit-PM15X104DS
Female pipe thread to 1/2. The valve shown has 1/2-in. Walls in back of the nook are plywood!). Dishwashing liquid to 1 cup water or with a commercially prepared leak testing solution. Well show you one way to make each connection, but there are other equally legitimate ways using common plumbing parts. Pipe thread compound, coat fittings threads with compound to help prevent leaks. Avoid purchasing a flexible hose that is too short or too long. There are built-in shelves over the area where the gas line is so no one is going to step on the gas line, but that doesn't mean it's up to code! Repeat the thread-sealing procedure for the gas line that comes from the dryer. Reuse a soft copper coil.